The mobile drum mix plants shown here are is of capacity 20-30 tph. These mobile asphalt plants come with 2 x 2 cold feed bins. The drying and mixing unit and the fuel tank for burner is on the same chassis with the cold feeder bins in the mobile asphalt drum mix plant. Mineral filler, bitumen tank and control cabin occupies another chassis of the mobile continuous asphalt mixing plant. Load out conveyor is tilting type to enhance mobility. The mobile asphalt plant can also be supplied with venturi type wet dust collector for pollution control.
The feeder supplied is a 2 x 2 bin type. Flow of aggregates from each bin can be regulated.
One conveyor belt takes the material from the feeder to the drying and mixing drum
The conveyor belt supplied with mobile drum mix plant runs from below the aggregate feeder to feed the materials into the drying and mixing drum.
The feeder, drying and mixing drum and fuel tank for dryer burner are set in one chassis.
DRYING AND MIXING DRUM OF MOBILE ASPHALT PLANT
The drying and mixing drum is the most important unit of the mobile asphalt drum mix plant. The burner equipped is very much capable of drying the aggregates to minimise the moisture content.
The drum is mounted on sturdy platform driven by chain drive. Thermometric instruments are fitted at right places to indicate the temperature of exhaust gases, bitumen and mix material.
FUEL TANK FOR DRYER BURNER
A small and compact 2000 liters fuel tank for dryer burner is near the cold feed bins of the mobile asphalt mixing plant.
DRY DUST COLLECTOR
Dry dust collector is a standard equipment with MDM 25 - mobile drum mix type asphalt plant.
WET DUST COLLECTOR
Venturi type wet dust collector unit can also be fitted with the mobile drum mix plant.
BITUMEN TANK WITH CONTROL CABIN
Bitumen tank and control cabin are in a single chassis along with mineral filler unit.
The size of the bitumen tank can be customized as per customer requirement. Bitumen tank is fully insulated to reduce heat loss.
Mineral filler unit is present to allow addition of minerals or dust back into the drying and mixing drum of mobile drum mixer equipment. Mineral filler inlet is adjacent to bitumen inlet in drying drum and is placed on the same chassis with bitumen tank and control cabin.
TILTING TYPE LOAD OUT CONVEYOR
The hot mix material discharged from the drying and mixing drum is discharged into the heat resistant load out conveyor. Load out conveyor is equipped with GOB hopper on the discharge end to control the segregation in the hot mix.